Do it yourself
| ||||
|
Nissan Qashqai - Video tutorial
Model: Nissan Qashqai
J10
- Years 2006-2014 The replacement of the rear light of the Nissan Qashqai model J10 follows very simple steps to be performed independently. The first step is to open the trunk. The second step is to remove the screws that secure the light with a 10mm Torx key. The third step is to extract the light and disconnect it from its connector. The fourth step is to install a new light, first connecting it to the connector and then inserting it into its housing. Tighten it with the screws and then proceed to replace the left light, following the same steps mentioned above.
Posted on 1 November 2023 by ScegliAuto
Other guides that may interest you |
Frequently Asked QuestionsHow to reset the tire pressure warning light on Dacia Sandero?Let's see below how it is possible to reset the low tire pressure signal on the car: first of all it is necessary to check the correct tire pressure by comparing it with the pressures reported in the use and maintenance manual. After that, turn on the ignition and locate the command on the right side of the steering wheel at the top that allows you to access the on-board computer menu, then select the car symbol, after which select the "up arrow" command up to that the indication "tire pressure" appears on the display. At that point, press the "Ok" control on the steering wheel and keep it pressed to reset the signal. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.054
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |