Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of Anti-Roll Bar Bush

Model: Vauxhall Vectra Vectra B, MK 2 - Years 1995-2002
Part: Bushings

If the vehicle is stiff and has lowered on the rear side, the problem lies with the torsion or support bar, so obtain the replacement parts and proceed with the replacement. Lift the vehicle, secure it, and remove the wheel. To remove the bush that maintains tension on the bar, it is necessary to lift the wheel with a hydraulic jack or another safe method to relieve the tension on the bar, allowing you to unscrew the bolts securing the bush. While keeping the vehicle in this position, install the new bush, ensuring to grease the joints.

Updated on 8 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Where to find the fuses and the OBD port on the Opel Vectra
Where to find the fuses and the OBD port on the Opel Vectra
Vauxhall Vectra (1995-2002 / Vectra B, MK 2) The instructions in this guide will show us where to find the fuse boxes and the OBD socket of the Opel Vectra, in simple steps. First, we open the f…
Where are the fuses of the Opel Vectra located (and the OBD port and the VIN number)?
Where are the fuses of the Opel Vectra located (and the OBD port and the VIN number)?
Vauxhall Vectra (2002-2008 / Vectra C, MK 3) In this video we see where some important components of the Opel Vectra are located: first of all we see where the EOBD (European On Board Diagnostic…
How to Remove the ABS Control Unit on the Opel Vectra
How to Remove the ABS Control Unit on the Opel Vectra
Vauxhall Vectra (1995-2002 / Vectra B, MK 2) To replace the ABS control unit on this car model, follow the instructions and steps outlined below. After opening the bonnet, the control unit is lo…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos