Do it yourself
Frequently asked questions about cars and motorcycles

How to Replace the Rear Shock Absorbers on an Opel Astra

Model: Vauxhall Opel Various
Part: Shocks

In this video tutorial, see how to replace the rear shock absorbers on an Opel Astra by following some essential steps: first, get into the vehicle, turn off the engine, and pull the handbrake; loosen the bolts of the rear wheel without fully unscrewing them; lift the rear of the car with a hydraulic jack and place safety stands under the vehicle; continue to unscrew the rear wheel, then remove the wheel. After removing the wheel, before unscrewing the shock absorber mounting bolts, place the jack under the vehicle (rear) and lift it slightly to support the axle from underneath and compress the spring. There are two bolts to unscrew, so start with the lower bolt (using a socket and a 20 mm socket), while for the upper bolt, you will need an 18 mm socket. Once the bolts are removed, you can take out the rear shock absorber and proceed with the replacement. To fit the new shock absorber, insert it as it was removed, align the hole properly, insert the bolts, and start tightening the upper bolt first, then the lower one (if the bolt does not fit, slightly raise or lower with the hydraulic jack). Refit the wheel and lower the vehicle.

Updated on 18 August 2026 by ScegliAuto

Video tutorial

Related tutorials

Vauxhall Opel Various Did you know that there is a shark hidden in every Opel built from 2004 onwards? Our friendly YouTuber shows that in the latest model of Opel Corsa, …
Vauxhall Opel Various The reset of the service light on an Opel vehicle is a very simple operation. On Opel Zafira and Opel Astra vehicles to perform the reset we must: - …
Vauxhall Opel Various Today we will explain how to replace the gear shift boot on Opel Astra model G and Opel Zafira model A vehicles. To replace the gear shift boot, you …

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos