Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 206
    4. : How to remove the cylinder head of the Peugeot 206 1.4

Peugeot 206 - Video tutorial

Model: Peugeot 206 MK 1 - Years 1998-2012
Part: Engine head
Operation: How to remove the cylinder head of the Peugeot 206 1.4

In this video tutorial we will see how to disassemble the cylinder head and its gasket of the Peugeot 206 with 1.4 petrol engine. First we open the engine hood and start removing the top cover of the cylinder head, unscrewing all the screws; then we remove the alternator belt and later also the timing belt, as shown in the video. At this point we remove the spark plugs and unscrew the head screws, in order to remove it; we clean the support base of the cylinder head and replace the gasket with the new one, following the video tutorial to the end!


Posted on 21 September 2022 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • 206 1998-2012 - How much does the head gasket cost for the Peugeot 206? Read Answer
    • 206 1998-2012 - How much does it cost to replace the head gasket on the Peugeot 206? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos