Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 107
    4. : How to open the fuse box in Peugeot 107

Peugeot 107 - Video tutorial

Model: Peugeot 107 MK 1 - Years 2005-2014
Part: Fuse box
Operation: How to open the fuse box in Peugeot 107

In today's video we see how to open the fuse box in the Peugeot 107. This tutorial also applies to the sister models Citroen C1 and Toyota Aygo. First of all, we recommend intervening on a cold engine, as it is a central area of the engine compartment. Once this is done we can open the front hood. We identify the fuse box, located in correspondence with the service battery and the air filter. Once this is done, release the two latches on the sides of the box, then remove the lid of the same. We therefore intervene where necessary, then we can proceed to reassemble everything.


Posted on 25 November 2022 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • 107 2005-2014 - Where is the horn fuse located on the Peugeot 107? Read Answer
    • 107 2005-2014 - Where is the fuse for the turn signals of the 107 located? Read Answer
    • 107 2005-2014 - Where are the fuse boxes located on the Peugeot 107? Read Answer
    • 107 2005-2014 - Where is the fuse box located, in the Peugeot 107? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos