Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Rear Light and Bulb on the Peugeot Boxer

Model: Peugeot Boxer MK 2 - Years 2006-2024
Part: Tail light bulb

Here are the steps to remove and replace the rear light and its bulbs on the Peugeot Boxer. First, move to the rear and open the two doors; then unscrew the internal screws of the rear light, disconnecting the electrical connector to remove it, as shown in the video. At this point, remove the rear light, then disassemble the bulb holder to access the bulbs; replace any faulty bulbs with new ones of the correct type and fitting, and reassemble the rear light!

Updated on 26 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the rear taillight of the Peugeot Boxer
How to replace the rear taillight of the Peugeot Boxer
Peugeot Boxer (1993-2006 / MK 1) To replace the rear taillight of the Peugeot Boxer, start by unscrewing the two outer screws of the taillight; once the screws are removed, detach th…
How to Replace the Mirror Bulb on a Peugeot Boxer?
Peugeot Boxer (2006-2024 / MK 2) To replace the mirror bulb on a Peugeot Boxer, use a tool to lever out the glass from the inside of the corresponding housing; once the glass is deta…
How to replace the headlight bulb of the Peugeot Boxer and Fiat Ducato
How to replace the headlight bulb of the Peugeot Boxer and Fiat Ducato
Peugeot Boxer (2006-2024 / MK 2) Replacing the front headlight bulb of the Peugeot Boxer or Fiat Ducato is a very simple operation to do independently, especially thanks to our short…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos