Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 2008
    4. : To reset the tire pressure warning light on the Peugeot 2008.

Peugeot 2008 - Video tutorial

Model: Peugeot 2008 MK 2 - Years 2019-2024
Part: Wheel
Operation: To reset the tire pressure warning light on the Peugeot 2008.

To reset the tire pressure warning on the Peugeot 2008, you can follow these steps: Turn on the car: Make sure the engine is on and the vehicle is in park (P) or neutral (N) mode. Find the reset button: Look for the tire pressure warning reset button. It is usually located in the glove compartment or on the car's center console. It may be marked with a tire icon or specific instructions. Turn on the ignition (without starting the engine): Turn the key in the ignition or press the Start button without starting the engine. Make sure all doors are closed. Press and hold the reset button: Press and hold the tire pressure warning reset button for a few seconds. You may need to use a thin tool like a pen to press the button if it is in a tight area. Release the button: After a few seconds, release the reset button. Check the warning: After the reset, the tire pressure warning should turn off or reset. You can verify if the warning has been properly restored by checking the tire pressure warning indicator light on the dashboard.


Posted on 19 January 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Peugeot 2008 2013-2019 - How to change a wheel on a Peugeot 2008? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos