Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to disassemble the rear bumper of the Peugeot 208

Model: Peugeot 208 A9, MK 1 - Years 2012-2019
Part: Rear bumper

Today's instructions will show us how to disassemble and replace the rear bumper of the Peugeot 208, following these simple steps. First, we open the rear hatch of the trunk and begin to remove all the clips located on the top and bottom of the rear bumper; then we remove the additional clips located on both sides of the wheel arches, as shown in the video. At this point, we start to detach the bumper on the sides until we remove it completely, replacing it with the new one; we properly secure it on the sides and install new clips if necessary.

Posted on 29 May 2024 by ScegliAuto

Video tutorial

Related tutorials

Removing the Rear Bumper of the Peugeot 208
Removing the Rear Bumper of the Peugeot 208
Peugeot 208 (2012-2019 / A9, MK 1) Follow these instructions to remove and replace the rear bumper of the Peugeot 208 in simple steps. First, open the boot and start unscrewing the fix…
How to Remove the Rear Bumper on a Peugeot 208?
How to Remove the Rear Bumper on a Peugeot 208?
Peugeot 208 (2012-2019 / A9, MK 1) In this tutorial, you will see how to remove the rear bumper on a Peugeot 208, an extremely simple and quick task. First, open the boot lid, then rem…
How do you remove the rear bumper of the Peugeot 208?
How do you remove the rear bumper of the Peugeot 208?
Peugeot 208 (2012-2019 / A9, MK 1) The procedure for removing the Peugeot 208 involves loosening the screws that fix the piece to its housing: these screws will be found inside the whe…

Other guides you may be interested in

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos