Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this brief and simple guide, you will learn how to replace the transmission oil of the Piaggio Vespa Px 125, as well as the Lml Star 125 2-stroke. First, place the central stand and start unscrewing the oil drain bolt located on the right side casing; use a 10 mm socket spanner to do this, allowing the oil to drain into a container for about ten minutes. Next, unscrew the filler screw to let the oil flow out more quickly; finally, top up the oil, following the video to the end!

Updated on 23 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Changing the Transmission Oil on the Piaggio Vespa Px 125 - Lml Star 125
Changing the Transmission Oil on the Piaggio Vespa Px 125 - Lml Star 125
Vespa Px 125 .. on the Piaggio Vespa Px 125, as well as on the Lml Star 125. First, place it on the central stand and start unscrewing the oil drain bolt located under.. …
How to Remove the Engine from a Piaggio Vespa PX 125 - Lml Star 125
How to Remove the Engine from a Piaggio Vespa PX 125 - Lml Star 125
Vespa Px 125 .. the bodywork of the Piaggio Vespa PX 125 and the LML Star 125. First, place the central stand on your scooter and start by removing the side storage.. …
How to Replace the Air Filter on the Piaggio Vespa PX 125 - LML Star 125
How to Replace the Air Filter on the Piaggio Vespa PX 125 - LML Star 125
Vespa Px 125 .. on the Piaggio Vespa PX 125, as well as the LML Star 125 and Star 150. First, remove the right side panel of the engine and start by taking off.. …

Guide to replacing the starter motor of the Piaggio Vespa ET4 150

Today's guide will show us how to disassemble and replace the starter motor of the Piaggio Vespa ET4 150 scooter, in simple steps. First, we put the scooter on the center stand and lift the seat; we remove the battery, disconnecting both terminals, and then remove the compartment under the seat, as shown in the video. At this point, we disconnect the intake hose to access the starter motor, unscrewing its fastening screws and disconnecting the wiring to remove it; all that's left is to replace it with the new original one, applying the reverse procedure!

Watch the video!


by ScegliAuto

More videos