Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the fuel pump of the Dodge RAM 2500.

Model: RAM 2500 DC, MK 3, D1, DR, DH, DM - Years 2002-2009
Part: Fuel pump

Today's procedure will illustrate how to disassemble and replace the fuel pump of the Dodge RAM 2500, following the instructions below. First, we lift the vehicle and begin to disassemble and remove the fuel tank by unscrewing the fastening screws and disconnecting the various fuel lines. Then, we proceed to remove the immersion pump from the tank by disconnecting the electrical connector of the fuel level sensor, as shown in the video. At this point, we install the new pump and finally reassemble the fuel tank!

Posted on 26 November 2023 by ScegliAuto

Video tutorial

Related tutorials

How to replace the brake pads on the Dodge RAM 2500
How to replace the brake pads on the Dodge RAM 2500
RAM 2500 (2009-2019 / MK 4, DS, DJ, D2) We see in this guide the procedure necessary for the disassembly and replacement of the front and rear brake pads of the Dodge RAM 2500. First we lif…
How to replace the rear light bulb on the Dodge Ram 2500?
How to replace the rear light bulb on the Dodge Ram 2500?
RAM 2500 (2009-2019 / MK 4, DS, DJ, D2) In order to replace the rear light bulb of the Dodge Ram 2500 you need to lower the door of the rear compartment of the car, so that you can access t…
How to reset the Trip A entry of the Dodge RAM 2500
How to reset the Trip A entry of the Dodge RAM 2500
RAM 2500 (2009-2019 / MK 4, DS, DJ, D2) If you want to reset the "Trip A" item relating to the partial kilometers traveled with your Dodge RAM 2500, all you have to do is read the following…

Other guides you may be interested in

How to Replace the Radio in a Ford Focus

First, engage the handbrake and put the car in a low gear to prevent it from rolling during the replacement. Next, lift the bonnet to disconnect the battery cables and protect the electronic components. Unscrew the two screws located under the front panel of the stereo. Use a plastic lever to lift the bottom of the stereo. Disconnect the connector at the bottom and also remove the stereo lock at the back. Now, install the new stereo following the guides from the old one.

Watch the video!


by ScegliAuto

More videos