Do it yourself
Frequently asked questions about cars and motorcycles

How to Pass a Cable from the Engine Bay to the Cabin of the Renault Trafic III

Model: Renault Trafic MK 3 - Years: 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025
Part: Checks and maintenance

See other generations:
Video tutorial

Let’s see how to pass a cable from the engine bay to the cabin on a Renault Trafic III: in the engine bay, locate a black rubber grommet on the passenger side; using a flat screwdriver, make a small hole in the bottom of the grommet. Look for an area without existing wires.

Use a thin cable to pass it into the cabin: it will exit in the glove compartment, which you will need to lower (this is normally done to access the fuse box). You will see the end of the cable you passed from the engine bay. Gently pull it towards you, and from the engine side, seal it with sealing tape or silicone sealant.

Add the cable to the fuse box with a piggyback connector to safely draw power.


Posted on 24 April 2026 by ScegliAuto


Related tutorials

Renault Trafic (2001-2014 / MK 2) Is the starter motor broken? To remove the starter motor from the engine bay, open and lift the bonnet. Disconnect the power terminals of the starter…
Renault Trafic (2014-2026 / MK 3) To perform a basic service on the Renault Trafic, you will need: engine oil that meets the specifications indicated for the vehicle, an oil filter, a…
Renault Trafic (2014-2026 / MK 3) This guide shows how to replace the pollen filter on a Renault Trafic III. It is located behind the glove compartment, and you need to look on the ri…

Other guides you may be interested in

    Frequently Asked Questions

    • Trafic 2014-2027 - Where is the inertia switch located in the Renault Trafic van? Read answer
    • Trafic 2014-2027 - Why does the Start and Stop of a Renault Trafic not work? Read answer

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos