Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Renault
    3. :
  3. Twingo
    4. : Removing the door panel on Renault Twingo

Renault Twingo - Video tutorial

Model: Renault Twingo Twingo 3, Twingo III - Years 2014-2023
Part: Door panel
Operation: Removing the door panel on Renault Twingo

Unscrew the screws located on the side (in the area which can only be accessed by opening the door) and the one located in the lower part of the panel. Remove the small screw cover behind the window control panel and unscrew the screw below. Do the same thing with the screw located behind the opening handle. Also remove, with a flat screwdriver or a plastic lever and or any pointed tool, the high protection present on the pillar, next to the window. With the same operation, raise the window control panel and disconnect the connector. Finally unplug the lock and remove the panel.


Posted on 7 January 2024 by ScegliAuto



Disassembly of the front door panel of the Renault Twingo
Renault Twingo (1993-2007 / Twingo 1) The steps to be able to disassemble the front door panel of the Renault Twingo are really very simple. First of all, we open the front door and start
How to remove the door panel of the Renault Twingo
Renault Twingo (2007-2014 / Twingo 2) Remove the door panel of a Renault Twingo? Let's see the disassembly of the door panel. We unscrew the screws placed in the space of the upper lever
How we remove the door panel on Renault Twingo
Renault Twingo (1993-2007 / Twingo 1) How to remove the door panel (front right) of a Renault Twingo: disconnect the battery terminals in the engine compartment, unscrew the tightening sc

Other guides that may interest you

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos