Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Renault
    3. :
  3. Megane
    4. : Turbine installation instructions

Renault Megane - Video tutorial

Model: Renault Megane Megane 1 - Years 1995-2003
Part: Turbine
Operation: Turbine installation instructions

When installing a new turbine or even a regenerated one, it is advisable to apply new seals, starting from that of the lubrication duct, and to install new captive pins in correspondence with the connections of the exhaust manifold flanges; then insert the new gaskets in correspondence with the aforementioned flanges and tighten using a new set of nuts; finally fill the turbine with a syringe using clean oil to make sure it is well lubricated even at the first start, even before the oil pump can guarantee the right pressure.


Posted on 10 August 2023 by ScegliAuto



Turbine installation instructions
Renault Megane (1995-2003 / Megane 1) Apply the new studs studs on the flange of the exhaust manifold where the turbine is to be housed; repeat the same operation on the turbocharger flan
How to disassemble the turbine of the Renault Megane
Renault Megane (2002-2010 / Megane 2) Let's see how to remove the turbine of a Renault Megane. We open the bonnet, lift it and put it in safety, remove the soundproofing panel from the en
Head gasket replacement
Renault Megane (2008-2015 / Megane III, Megane 3) When replacing the cylinder head it is practically necessary to remove the entire upper part of the engine, leaving only the cylinder block: it is go

How do you replace the horn on the Citroà «n Berlingo?

In order to replace the horn on the Citroà «n Berlingo, the vehicle must be raised so that the screws that secure the left front wheel can be loosened and removed completely. Once this wheel has been removed, it will be possible to access the screws that secure the internal cover of the corresponding wheel arch: this will have to be detached and it will be possible to access the components inside, including the horn. This will need to be disconnected from its connector and removed from its holders, so that it can be replaced with a new spare part.

Watch the video!


by ScegliAuto

More videos