Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Renault
    3. :
  3. Megane
    4. : Guide to replacing the clutch master cylinder of the Renault Megane

Renault Megane - Video tutorial

Model: Renault Megane Megane 2 - Years 2002-2010
Part: Pump
Operation: Guide to replacing the clutch master cylinder of the Renault Megane

Let's see in this guide the main instructions for disassembling and replacing the clutch pump or master cylinder of the Renault Megane. First of all, we open the bonnet and start removing the battery, lifting the car to remove the front wheels; after which we disassemble the engine support to later remove the gearbox, thus accessing the clutch pump, as shown in the video. At this point we disconnect the pump and replace it with the new one, with its original spare part; we just have to reassemble everything, applying the reverse procedure!


Posted on 8 June 2022 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Megane 2002-2010 - How much does it cost to replace the clutch master cylinder in Renault Megane? Read Answer
    • Megane 2002-2010 - How much is the clutch master cylinder of the Renault Megane II? Read Answer
    • Megane 2008-2015 - Where is the fuel pump located in the Renault Megane? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos