Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to change the rear wheel bearing on a Renault Clio 3?

Model: Renault Clio MK 3, Clio 3, Clio III - Years 2005-2013
Part: Bearing

To carry out this operation, ensure the car is raised on a ramp. Start by removing the wheel by unscrewing the fixing bolts. Once this is done, you can also unscrew the hub mounting bracket as shown in the video and remove it. At this point, proceed to remove the old wheel bearing using a hydraulic press, and after lubricating the area with a suitable release spray, insert the new bearing. Refit the wheel hub and its bracket, and also install the protective cap. Finish by refitting the wheel and tightening the bolts.

Updated on 6 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Wheel Bearing on a Renault Clio
How to Remove the Wheel Bearing on a Renault Clio
Renault Clio (1998-2005 / Clio 2, MK 2) How to remove a wheel bearing along with all associated parts on a Renault Clio. Position the car on a column lift, loosen the bolts with a telescopi…
How to Remove the Front Brake Disc Bearing on Renault Clio
How to Remove the Front Brake Disc Bearing on Renault Clio
Renault Clio (1998-2005 / Clio 2, MK 2) How do you remove the front brake disc bearing on a Renault Clio? First, position your car on a column lift (jack), loosen the bolts with a socket wr…
Front Wheel Bearing Replacement
Front Wheel Bearing Replacement
Renault Clio (1998-2005 / Clio 2, MK 2) Lift the vehicle on a hydraulic lift and remove the wheel; then remove the brake caliper, the tie rod end of the steering rack, and the fixing bolts …

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos