Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Seat
    3. :
  3. Leon
    4. : How to assemble the component kit to fix the turbine

Seat Leon - Video tutorial

Model: Seat Leon 1M - Years 1999-2005
Part: Turbine
Operation: How to assemble the component kit to fix the turbine

This video shows how to assemble the components that allow you to fix the turbine of a Seat Leon. After obtaining the kit, open it carefully and remove the various pieces. First screw the three grub screws into the slots next to the nut and secure them with a ratchet. Fit the washer of the piston and then tighten the latter. Insert and assemble the manifold gasket: screw and tighten the two cubes that fix it. Then take the quadruple gasket of the kit, position it and fix it to the cylinder head as shown in the video. Proceed to assemble the turbine by mounting and fastening the eight locking nuts. With a syringe filled with clean oil (of the same type used for the engine) lubricate the turbine. Install the exhaust manifold with its new gasket.


Posted on 5 August 2023 by ScegliAuto



Turbine lubrication tube replacement
Seat Leon (1999-2005 / 1M) The lubrication of the turbine is absolutely fundamental given the high number of revolutions and the constant contact with the exhaust gases charact
Turbine lubrication tube replacement
Seat Leon (1999-2005 / 1M) Guaranteeing the lubrication of the turbine is absolutely essential given the high number of revolutions and the constant contact with the high tempe
Complete overhaul instructions tested
Seat Leon (1999-2005 / 1M) After flattening the cylinder head, use a ground bar and a thickness gauge for valves to check the perfect flatness of the surface; then proceed with

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos