Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Cabin Fan Resistor on the Seat Altea

Model: Seat Altea MK 1 - Years: 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015
Part: Blower motor

Video tutorial

In this brief and simple guide, we will go through the steps on how to remove and replace the cabin fan resistor on the Seat Altea. First, move to the passenger side and start by removing the plastic panel located under the glove compartment by unscrewing the fixing screws; then disconnect the resistor cable by unplugging it from the electrical connector, as shown in the video.

At this point, install the new resistor and test the operation of the air conditioning at various speeds; then reassemble everything, following the video tutorial to the end!


Updated on 21 August 2026 by ScegliAuto


Related tutorials

Disassembly of the Seat Altea cabin fan.
Disassembly of the Seat Altea cabin fan.
Seat Altea (2004-2015 / MK 1) Following these short and simple steps, we will see how to disassemble and replace the cabin fan of the Seat Altea. First, we get on board the vehicl…
How to Remove the Heater Fan on the Seat Altea
How to Remove the Heater Fan on the Seat Altea
Seat Altea (2004-2015 / MK 1) Want to remove the heater fan on a Seat Altea? Follow these steps to disassemble the cover pieces to reach the air fan. Open the glove compartment do…
Where are the fuses located in the Seat Altea?
Where are the fuses located in the Seat Altea?
Seat Altea (2004-2015 / MK 1) Any fuse in the Seat Altea is located inside one of the two fuse boxes installed within the vehicle: the first is behind the glove compartment, which…

Other guides you may be interested in

How to Remove the Toll Tag Holder from the Car Windscreen

The toll tag holder is usually attached to the car windscreen to ensure that the toll tag functions immediately when passing through barriers. However, if you decide to remove the holder, you should follow this procedure: - Insert the toll tag into the holder; - Pull the holder inwards to detach it from the windscreen; you can use a glass scraper or a stiff plastic card to assist you; After removing the holder, it is essential to remove the adhesive from the windscreen. To remove the adhesive, we recommend using a solvent-based spray that will remove the glue without clouding the area.

Watch the video!


by ScegliAuto

More videos