Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to remove a bumper cover from a 2008 Subaru Outback

Model: Subaru Outback BL, BP, MK 3 - Years 2003-2009
Part: Rear bumper

To remove the bumper cover of a 2008 Subaru Outback you must first remove the taillights and then remove the screws on the sides of the cover with a screwdriver. On the inside of the bonnet, on the sides, there are two bolts number 10 which must be extracted, use a magnet to prevent them from falling into the body. Now remove the bumper screws located in the wheel arch, applying a little pressure. Positioning under the car, then remove the four screws and the bolt that hold the cover. At this point, it will be possible to extract the bumper, first unhooking one side and then the other.

Posted on 12 December 2021 by ScegliAuto

Video tutorial

Related tutorials

Subaru Outback Front Bumper Grille Replacement
Subaru Outback Front Bumper Grille Replacement
Subaru Outback (2003-2009 / BL, BP, MK 3) Today we will see, in this short and simple video, how to remove and replace the front bumper grille of the Subaru Outback. First of all we go to rem…
How to remove the rear bumper of a Subaru Outback
How to remove the rear bumper of a Subaru Outback
Subaru Outback (2014-2019 / MK 5, BS) To be able to change the rear bumper of your Subaru Outback, you need to identify two small openings hidden in the bodywork of your car. Here are the…
How to remove the headlights of the Subaru Outback 3
How to remove the headlights of the Subaru Outback 3
Subaru Outback (2003-2009 / BL, BP, MK 3) Today we will see the procedure necessary to disassemble and replace the headlights of the Subaru Outback third series, following these simple steps.…

Other guides you may be interested in

How to Replace the Diesel Filter on a Fiat Freemont

How to replace the diesel filter on a Fiat Freemont? In this video, we will show the replacement: open the car door and pull up the engine compartment release lever located at the bottom left of the dashboard, lift the front bonnet and secure it. Remove the engine soundproofing panel, then use a socket to unscrew the bolts on the plate that supports the filter (disconnect the wires and various pipes from the filter) where it is located. Extract the diesel filter and replace it with a new one. Finally, reassemble the diesel filter container (connect the pipes and wires) and tighten the screws. Close the front bonnet at the end.

Watch the video!


by ScegliAuto

More videos