Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Procedure to Replace Engine Oil and Oil Filter in a Suzuki Jimny

Model: Suzuki Jimny Jb64w, Jb74w - Years 2018-2026
Part: Engine oil

Lift the bonnet and secure it with the appropriate prop. Now, you need to drain the engine oil while the engine is still warm. Remove the oil filler cap and the dipstick. Raise the car using a hydraulic jack and place safety stands underneath. Unscrew the engine oil drain plug with a 14 mm socket. Position a container to collect the used oil under the oil sump. Before unscrewing the oil filter, you must re-tighten the oil drain plug. Unscrew the oil filter (using the appropriate tool) and clean any parts stained with used oil. Before fitting the new filter, oil the seal with new oil. Tighten the filter by hand. Unscrew the oil drain plug and replace the old washer with a new one; tighten the plug to a torque of 35 Nm. Obtain a funnel to top up with new oil (top up with 3.6 litres of oil); insert the dipstick and close the cap. Start the engine for about a minute. Wait about 5 minutes with the engine off and then check the oil level again, topping up if necessary.

Updated on 12 August 2026 by ScegliAuto

Video tutorial

Related tutorials

Oil Filter Replacement for Suzuki Jimny
Oil Filter Replacement for Suzuki Jimny
Suzuki Jimny (1998-2018 / Jb23, Jb33, Jb43, Jb53) In this video tutorial, you will learn how to replace the oil filter on a Suzuki Jimny. First, open the bonnet from inside the car and remove the eng…
How to Change the Engine Oil on a Suzuki Jimny?
How to Change the Engine Oil on a Suzuki Jimny?
Suzuki Jimny (1998-2018 / Jb23, Jb33, Jb43, Jb53) Today, discover the main steps to perform routine maintenance by changing the engine oil and oil filter on the first series Suzuki Jimny in simple an…
Resetting the Service Light on the Suzuki Jimny
Resetting the Service Light on the Suzuki Jimny
Suzuki Jimny (2018-2026 / Jb64w, Jb74w) The procedure to reset the service light for the engine oil change on the Suzuki Jimny is very straightforward. The video initially demonstrates the …

Other guides you may be interested in

How to Replace the Battery on a Honda Vision 110

To replace the battery on a Honda Vision 110, you need to remove the front fairing of the motorcycle, located directly under the front headlamp. To loosen this panel, unscrew the two screws found at its top, just below the handlebar. Once these screws are loosened, lever under the panel to detach it, gaining access to the battery underneath: this battery must be removed from its housing by unscrewing the fixing screws and disconnecting the power cables, replacing it with a new one.

Watch the video!


by ScegliAuto

More videos