Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Tata
    3. :
  3. Tiago
    4. : How to replace the oil and oil filter of the Tata Tiago

Tata Tiago - Video tutorial

Model: Tata Tiago MK 1 - Years 2016-2023
Part: Engine oil
Operation: How to replace the oil and oil filter of the Tata Tiago

To change the oil and the oil filter of the Tata Tiago, we start by going under the car, unscrew the engine oil drain plug with a special wrench, let the oil drain into a container; now we are going to remove the oil filter with a special wrench, unscrew it and let the oil drain into a container. Drained all the oil, screw the new oil filter, not before having smeared oil on the gasket and having cleaned the filter seat, screwed the oil filter with a special wrench, clean the drain plug of the oil and its seat, we screw it back with a special wrench; now we go to the top of the engine, unscrew the oil filler cap, pour the liters indicated by the house and when we are approximately at the indicated liters, we carry out a check by extracting the oil dipstick, we clean it, the we reinsert and check the level; if the oil level is on the max mark we can insert the dipstick in its seat, otherwise if it is below the max mark we top up, then close the oil filler cap. Finally we go inside the car, start the engine and leave it running for a few minutes and close the bonnet.


Posted on 29 April 2024 by ScegliAuto

Other guides that may interest you

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos