Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Heating Resistor in the Toyota Corolla?

Model: Toyota Corolla MK 2 - Years 2000-2007
Part: Air conditioner

In this tutorial, you will see how to replace the heating resistor in the Toyota Corolla, an extremely simple and quick operation. First, ensure that the key is not inserted for safety, then position yourself on the passenger side, open the glove compartment, and disconnect the end stop damper. Next, unclip the drawer from the dashboard, locate the resistor, and disconnect its power connector. Now, simply unscrew the two securing screws, remove the resistor, insert the replacement, and reassemble everything by following the reverse procedure.

Posted on 7 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to remove the rear bumper from a Toyota Corolla
How to remove the rear bumper from a Toyota Corolla
Toyota Corolla (2019-2026 / MK 5, E210) Before you can begin, open the tailgate of the boot on your Toyota Corolla. Start by unscrewing and removing the screws that secure the rear bumper t…
How to Remove the Rear Seat Bench of a Toyota Corolla
How to Remove the Rear Seat Bench of a Toyota Corolla
Toyota Corolla (2006-2013 / MK 3) Before you can start, open the rear doors of your Toyota Corolla. Begin by inserting a thin, long, and sturdy tool under the rear seat bench. Then, l…
How to Fold Down the Rear Seats of a Toyota Corolla
How to Fold Down the Rear Seats of a Toyota Corolla
Toyota Corolla (2006-2013 / MK 3) Before you begin, open the rear doors of your Toyota Corolla. Start by pulling upwards on the hooks located at the upper corners of the rear seats to…

Other guides you may be interested in

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos