Do it yourself
| ||||
|
Toyota Rav 4 - Video tutorial
Model: Toyota Rav 4
MK 2, Xa20
- Years 2000-2006 To replace the stabilizer bar links in a Toyota RAV 4 II: Get into the vehicle, turn off the car and apply the handbrake. Loosen the wheel bolts, lift the car with a hydraulic jack and place safety stands under the car; continue unscrewing the bolts and then remove the wheel. Clean the stabilizer link fastener (uses WD-40 spray); remove the cross stabilizer link. Fit new cross stabilizer link, (screw in using a 14 bit socket). Clean the mounting seat of the wheel rims. Refit the wheel and then lower the vehicle to the ground.
Posted on 17 May 2023 by ScegliAuto
Other guides that may interest you
|
How to replace the Ford Transit key batteryBelow I will explain how to replace the remote control key battery on the car, take a small screwdriver and pry the rear part of the remote control, (where there is the ring), at which point unhook the back cover and yes will have access to the compartment containing the battery. Always with the help of the small screwdriver, proceed to make the va and lift the battery out of the housing. Then take the new battery (check the type) and place it on the housing, always making sure to position it with the positive pole facing upwards. Finally, close the back cover by re-hooking it to the key. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.025
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |