|
Do it yourself
| |||
| ||||
How to Replace the Wheel on a Toyota Tacoma
Model: Toyota Tacoma
N300
- Years 2016-2026
To replace the wheel on a Toyota Tacoma, go to the back seats, lift the seats, open the doors, and get the tools with the jack; go to the back of the truck, connect all the tools by interlocking them and insert the hook end into the hole above the license plate all the way in; rotate the tools so the wheel lowers; when the wheel is on the ground, remove the wheel from the hub and rotate the tools to lift it up, then remove the tools, separate them, place them in their case, and store them in the drawer under the back seat along with the jack (because a shop jack is used in the video), securing it with the hook, close the doors, and lower the back seat; take the shop jack, position it under the rear axle, raise the truck until the wheel is off the ground, unscrew the bolts (in a crisscross pattern) and remove the wheel. After removing the wheel, take the spare, position it on the hub, screw in the bolts (in a crisscross pattern), and place the flat tire in the trunk.
Updated on 23 July 2026 by ScegliAuto
Video tutorial
Related tutorials
Toyota Tacoma
(2005-2015 /
N270, N260, N250, N240, N220, MK 2)
To replace the rear shock absorber on a Toyota Tacoma, lift the vehicle so that the corresponding rear wheel is off the ground. Once the wheel is lif…
Toyota Tacoma
(1995-2004 /
N150, N190, N140, N160, N170)
To replace the front shock absorber on a Toyota Tacoma, lift the vehicle with a jack so that the wheel corresponding to the shock absorber being repl…
Toyota Tacoma
(2016-2026 /
N300)
To replace the front shock absorber of the Toyota Tacoma, you need to remove the wheel corresponding to the shock absorber being replaced: by unscrew…
Other guides you may be interested in
|
How to Repair the Key Spring of the Peugeot 207?
Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.071
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
