Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace a Flat Tyre

Model: (Various brands) Various
Part: Wheel

Here’s how to replace a flat tyre using a spare wheel. Park the vehicle in a safe area where you can work securely, turn off the engine, pull the handbrake, activate the hazard lights, wear a high-visibility vest, and place the warning triangle 50 metres from the vehicle. Remove any wheel trims or hubcaps from the wheel, position the jack near the wheel at the height of the mark on the bodywork without lifting the car. Using the appropriate tool, loosen the bolts securing the wheel and begin to lift the car until the wheel is off the ground. Completely unscrew the bolts and remove the wheel, using gentle taps on the rim if necessary. Place the spare wheel onto the hub, aligning the pins, insert the bolts, screwing them in initially by hand, then use the tool to tighten them in a criss-cross pattern without over-tightening. Lower the car back to the ground using the jack and finally tighten the bolts, again in a criss-cross pattern.

Updated on 14 September 2026 by ScegliAuto

Video tutorial

Related tutorials

An Emergency Solution to Repair a Punctured Motorcycle Tyre
An Emergency Solution to Repair a Punctured Motorcycle Tyre
(Various brands) Various In this video, you will see an emergency method (and we emphasise "emergency") to repair a punctured motorcycle tyre. Naturally, on a motorcycle, the…
How to easily mount the spare wheel
How to easily mount the spare wheel
(Various brands) Various How to mount the spare wheel if we have a flat tire? Actually, it is much simpler than you think. First of all, we need to understand if we have a re…
How to program the tire pressure sensor using Autel Maxi TS408
How to program the tire pressure sensor using Autel Maxi TS408
(Various brands) Various When we want to update or program the tire pressure sensor on any vehicle we own, we must use the Autel Max model TS 408 tool. We connect the updatin…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos