Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install a Dash Cam While Hiding the Wires

Model: (Various brands) Various
Part: Body

In this video, learn how to install a dash cam without showing any wires, completely hiding them and without tools. After applying the dash cam in the unshaded area of the windscreen, run the cable through the seal that runs along the top of the windscreen. When you reach the passenger side pillar, you can pass the cable inside it without removing it, guiding it to the seal on the other side, and then down through the door to the glove compartment. Here, you can easily tuck it inside the glove box, perhaps securing it with some adhesive strips to ensure it doesn't interfere with the glove box closure. Then, run the cable through the central console panel until it reaches the cigarette lighter socket, which is also a power socket. Here, plug in your charger, and the installation is complete.

Updated on 18 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Connect the Dash Cam Wiring Kit
How to Connect the Dash Cam Wiring Kit
(Various brands) Various Learn how to connect the permanent wiring kit of a dash cam so that it operates normally when the engine is running; it enters parking mode (recordin…
How to Install a Car Radio
How to Install a Car Radio
(Various brands) Various The car radio is one of the most common and used items in a vehicle, often updated to keep pace with current technology. Here are the main steps for …
How to Connect a 12V Car Accessory Without a Cigarette Lighter Socket
How to Connect a 12V Car Accessory Without a Cigarette Lighter Socket
(Various brands) Various In this video, we will see how to install an electronic accessory without using the cigarette lighter socket, opting for a direct connection to the f…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos