|
Do it yourself
| |||
| ||||
Replacement of the ignition cylinder of the Volkswagen Jetta
Model: Volkswagen Jetta
MK 5, A5
- Years:
2005, 2006, 2007, 2008, 2009, 2010
Video tutorial
Today we will discover the instructions that will allow us to disassemble and replace the ignition cylinder of the Volkswagen Jetta. First, we get on board the car and start removing the plastic panel under the steering wheel; then we proceed to remove the ignition cylinder pin, smoothing it with a tip, as shown in the video. At this point, we disconnect the electrical connector to finally remove the cylinder, carrying out the repair or replacement with the new one; we reassemble everything and verify the correct functioning of the key!
Posted on 28 February 2025 by ScegliAuto
Related tutorials
Volkswagen Jetta
(2005-2010 /
MK 5, A5)
Below are the instructions for testing the operation of the starter motor on the Volkswagen Jetta. First, remove the starter motor by unscrewing the …
Volkswagen Jetta
(2005-2010 /
MK 5, A5)
In this guide, we will discover the instructions that will allow you to bleed and drain the fuel from the supply system of the Volkswagen Jetta 1.9 T…
Volkswagen Jetta
(2010-2018 /
MK 6, A6)
Before starting, sit in the driver's seat of your Volkswagen Jetta. Begin by pressing and holding the "0.0" button located below the multifunction di…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.
Other guides you may be interested in
|
Where is the Fuel Pump Relay Located in an Opel Corsa?
If the fuel pump in your Opel Corsa suddenly stops working, and the corresponding fuse is not blown, you can check the status of the respective relay, the position of which is indicated in this video. As shown, the relay is located in the box within the engine compartment, protected by the black cover situated just behind the left headlamp. If the relay is found to be faulty, ensure you replace it with a spare of the same specifications and always operate with the vehicle switched off; otherwise, you may cause damage to various devices or to yourself. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.072
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy - About us VAT number: IT01247470535 |