Do it yourself
Frequently asked questions about cars and motorcycles

How do you check and how do you remove the BCM on a Volkswagen T6 Transporter?

Model: Volkswagen Transporter T6, MK 6 - Years: 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025
Part: Air filter

See other generations:
Video tutorial

To check and remove the BCM (Body Control Module) on a Volkswagen T6 Transporter, you first need to know where it is located. Usually, it is behind the dashboard, under the steering wheel, or in the area of the ECU. In this type of car, it is located behind the dashboard.

First of all, disconnect the battery to avoid short circuits or damage to the components. Then remove the panels or covers that hide the BCM, being careful not to damage anything.

Once visible, disconnect the electrical connectors, which may be a bit tough, and then unscrew any fixing screws. If the module is defective, you can replace it with a new or used one, but remember that it needs to be programmed for the vehicle.

Finally, reassemble everything and test the operation. If you are not sure, it is better to rely on an experienced mechanic.


Posted on 1 April 2025 by ScegliAuto


Related tutorials

Volkswagen Transporter (2003-2014 / T5, MK 5) In this short guide, discover the instructions on how to disassemble and replace the BCM (Body Control Module) of the Volkswagen Transporter. First, …
Volkswagen Transporter (2014-2025 / T6, MK 6) The AdBlue light on the Volkswagen Transporter indicates that the additional fluid in the tank is nearly depleted: therefore, you can reset the light…
Volkswagen Transporter (2003-2014 / T5, MK 5) The timing belt of the Volkswagen Transporter can be replaced by lifting the vehicle so that the right front wheel is not in contact with the ground:…

Other guides you may be interested in

How to Activate the Disabled TRC on the Toyota Yaris?

As the video clearly shows, disabling or activating the traction control (TRC or ESP) on the Toyota Yaris is very simple. By default, the traction system activates every time the vehicle is started. To disable it, simply press the button depicting a skidding car located in the centre of the vehicle where the controls are, such as the hazard lights and the radio, but near the handbrake. Once disabled, the TRC off light will illuminate on the dashboard. To reactivate it, just press the same button again.

Watch the video!


by ScegliAuto

More videos