Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Jetta
    4. : Replacement pedal covers with new design

Volkswagen Jetta - Video tutorial

Model: Volkswagen Jetta A6, MK 6 - Years 2010-2018
Part: Accessory Kit
Operation: Replacement pedal covers with new design

After having obtained the necessary kit for the operation, begin to remove the plastic protection placed under the steering column by removing the two screws. Now you can access the screws that hold the accelerator pedal anchored. Remove the two screws holding the pedal located at the base so that it can be brought into a suitable position to allow the connector to be released. For this delicate operation, use a flat blade screwdriver that is inserted into the appropriate slot to allow leverage. Install the new pedal in reverse order. Then remove the old pedal covers and replace them with the new ones. Finally, remove the side covers to access the footrest block sealing screw, which must be replaced with the new one. Reassemble the various disassembled parts.


Posted on 11 July 2023 by ScegliAuto



How to replace the clutch master cylinder on the Volkswagen Jetta?
Volkswagen Jetta (1998-2005 / A4, MK 4) In order to replace the Volkswagen Jetta clutch pedal pump, you need to remove the plastic cover of the dashboard which is located immediately under
Replacement of the rear brake light switch of the Volkswagen Jetta
Volkswagen Jetta (2005-2010 / MK 5, A5) Below we will see the main instructions useful for disassembling and replacing the rear brake light switch of the Volkswagen Jetta, but also of the G
How to deactivate the traction control of the Volkswagen Jetta
Volkswagen Jetta (2005-2010 / MK 5, A5) To deactivate the traction control on a Volkswagen Jetta, start by turning on the instrument panel without starting the car's engine. Turn on the haz

How to set the clock on the Yamaha Xmax 300

To change the time of the Yamaha Xmax 300, keep the "trip" button pressed, at the same time turn the ignition to "on"; release the "trip" button when the time starts flashing; briefly press the "trip" button to set the time; press and hold for a few seconds to confirm and move on to the minutes; briefly press the same button to set the minutes; we long press the same "trip" button to confirm; at this point in the meantime that we hold down the minutes stop flashing the time has been saved correctly and we can turn off the instrument panel.

Watch the video!


by ScegliAuto

More videos