Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Polo
    4. : Removing the headlight and bumper on Volkswagen Polo 9N

Volkswagen Polo - Video tutorial

Model: Volkswagen Polo Polo 4, MK 4, Polo IV, 9N, MK IV - Years 2001-2009
Part: Headlight
Operation: Removing the headlight and bumper on Volkswagen Polo 9N

Let's see in this video how to remove the headlight, together with the front bumper, on a Volkswagen Polo 9N. First we open the bonnet and we go to remove the front plastic grille, unhooking the levers and unscrewing the fixing screws with a torx key; after which we unscrew the additional torx screws that we find on the upper part of the bumper and on the lower part. At this point we remove the screws on both sides of the fenders and remove the front bumper. At this point we unscrew the fixing screws of the light, in order to remove it; finally disconnect the electrical connector of the lights!


Posted on 12 January 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Polo 2001-2009 - How do you replace the front headlight of the Volkswagen Polo 8? Read Answer
    • Polo 2001-2009 - How much does the right headlight of a Volkswagen Polo cost? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos