Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Speakers

Model: Volkswagen Golf Golf 6, MK 6, 5K1, Golf VI - Years: 2008, 2009, 2010, 2011, 2012
Part: Speaker

See other generations:
Video tutorial

Start by removing the handle cover, then unscrew the screw located on the edge of the door at the height of the air vent. Using a plastic spatula, gently remove the panel along the edges, which should be carefully pulled upwards.

Disconnect the electrical contacts by unplugging the connectors, taking care not to tear them. Remove the speaker bracket and take it out. Remove the speaker from the bracket by unscrewing the four screws and install the new one, also replacing the foam gasket with a new one. Reassemble the new panel, starting with the connection of the electrical cables.

Position the panel upwards and then push it down until it clicks into place. Replace the screws.


Updated on 8 February 2026 by ScegliAuto


Related tutorials

Replacing the Panel on a Golf 6
Replacing the Panel on a Golf 6
Volkswagen Golf (2008-2012 / Golf 6, MK 6, 5K1, Golf VI) Remove the cover panel of the Golf 6 if you want to replace it or work inside the door. Pry at the internal handle: remove the entire trim from above…
Replacement of rear speakers of the Volkswagen Golf
Replacement of rear speakers of the Volkswagen Golf
Volkswagen Golf (2012-2019 / MK 7, Golf 7, Golf VII) The following steps will show us how to disassemble and replace the rear door speakers of the Volkswagen Golf. First, we open the rear door of the ca…
Replacement of the front speakers of the Volkswagen Golf
Replacement of the front speakers of the Volkswagen Golf
Volkswagen Golf (2012-2019 / MK 7, Golf 7, Golf VII) In today's video, we will see how to disassemble and replace the front speakers of the Volkswagen Golf. First, we open the front door and start disas…

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!


by ScegliAuto

More videos