Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of the Front Headlamp Bulb

Model: Volkswagen New Beetle 9C, MK 2 - Years: 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010
Part: Brake rotors

See other generations:
Video tutorial

Once the vehicle is raised on the ramp, remove the front wheel and proceed to dismantle the brake caliper after removing the protective caps from the fastening pins; then disconnect the wear sensor connector and remove the retaining spring of the pads before removing the caliper.

Next, remove the caliper bracket and then the disc (you may need to tap it with a hammer to free it from the hub). Clean the new disc of protective oil and install it on the hub, tightening the corresponding fastening pin. Then install the caliper bracket, insert the new pads, and then the caliper after retracting the piston using a C-clamp or a pair of pliers.

Finally, attach the retaining spring of the pads, the wear sensor, and pay attention during the first braking.


Updated on 11 February 2026 by ScegliAuto


Related tutorials

Front Headlamp Bulb Replacement
Front Headlamp Bulb Replacement
Volkswagen New Beetle (1999-2012 / 9C, MK 2) To replace the front headlamp bulb, it is necessary to remove the headlamp itself as access to the bulb holder is not possible. The headlamp is secur…
Front Headlamp Bulb Replacement
Front Headlamp Bulb Replacement
Volkswagen New Beetle (1999-2012 / 9C, MK 2) Open the front bonnet and remove the headlamp: by pressing on the plastic latch and rotating the tab, you can detach the headlamp and pull it forward…
How to Replace the Front Headlamp Bulb on the Volkswagen New Beetle?
How to Replace the Front Headlamp Bulb on the Volkswagen New Beetle?
Volkswagen New Beetle (2011-2018 / MK 3) To replace the front headlamp bulb on the Volkswagen New Beetle, open the bonnet to access the components inside the engine bay: at the back of the h…

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos