|
Do it yourself
| |||
| ||||
How to Replace the Track Rod Ends of the VW Passat 5
Model: Volkswagen Passat
3BG, B5
- Years:
1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005
Video tutorial
Replacing the track rod ends of the Volkswagen Passat, model B5, is a relatively simple task that can be done independently, thanks to our short video tutorial that will guide you through the steps for the replacement. Start the replacement operation by removing the tyre cover and then the wheel itself. Continue the disassembly by lifting the vehicle and clean the fastening element that connects the track rod ends to the steering knuckle. After cleaning, use a 15 mm socket to unscrew the nut that attaches the rod to the knuckle and remove the fixing bolts. Using a hammer and chisel, remove the rod. At this point, loosen the lock nut that attaches the tie rod to the bar with an 18 mm and a 22 mm spanner. Unscrew the rod and screw in a new steering track rod end. Apply copper grease to the threaded part of the rod and insert it to connect the rod to the knuckle, tightening the nut with a 13 mm spanner and fitting the bolt. Tighten the locking nut and the lock nut. Tighten the various bolts and reassemble the wheel.
Updated on 11 September 2026 by ScegliAuto
Related tutorials
Volkswagen Passat
(1996-2005 /
3BG, B5)
The upper wishbone of the front suspension in this vehicle has a rather unique geometry, consisting of two links that extend from the shock absorber …
Volkswagen Passat
(2005-2010 /
B6, 3C)
Unscrew the Torx T20 screw located under the steering wheel, as shown in the video, then pull the lever underneath the steering column to pull the st…
Volkswagen Passat
(2010-2014 /
B7)
Good morning! Today, focus on locating and accessing the fuse box of your Volkswagen Passat. Start by opening the door on the right side of the drive…
Other guides you may be interested in
|
How to Activate the Disabled TRC on the Toyota Yaris?
As the video clearly shows, disabling or activating the traction control (TRC or ESP) on the Toyota Yaris is very simple. By default, the traction system activates every time the vehicle is started. To disable it, simply press the button depicting a skidding car located in the centre of the vehicle where the controls are, such as the hazard lights and the radio, but near the handbrake. Once disabled, the TRC off light will illuminate on the dashboard. To reactivate it, just press the same button again. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.021
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |