Do it yourself
| ||||
|
Volvo Xc90 - Video tutorial
Model: Volvo Xc90
MK 1
- Years 2002-2014 The video shows the manual procedure for resetting the service warning light in the Volvo Xc90. First of all you need to locate the button located at the bottom right of the odometer. If the maintenance indicator flashes it could mean that one of the maintenance parameters has not been programmed. To do this it is necessary to use a suitable diagnostic tool. Also check that there are no fault codes indicated in the instrument panel. At this point, we can begin the reset procedure. Close all the doors of the car and turn on the ignition by placing the key in position | (partial ignition). Press and hold the button in position |. Within 4 seconds, from the start of the previous operation, turn the key to position || (always holding down the | key). When the maintenance indicator starts flashing, release the button within 5 seconds. At the end, an acoustic signal will indicate the successful reset.
Posted on 5 October 2023 by ScegliAuto
How to reset the service light in Volvo XC90?
Volvo Xc90 (2002-2014 / MK 1) In this tutorial we can see how to reset the service warning light in the Volvo XC90. Before carrying out this simple operation, make sure that you h
How do you reset the Service light on the Volvo XC90?
Volvo Xc90 (2002-2014 / MK 1) To reset the Service light on the Volvo XC90, you need to insert the ignition key into the ignition block so that it can be turned on. Once the dashb
How to reset the service light on the Volvo XC90
Volvo Xc90 (2002-2014 / MK 1) If the maintenance message appears on the instrument panel of your first-generation Volvo XC90, even though the service has already been performed, d Other guides that may interest you
|
How to reset the oil service in the Fiat Toro?In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.065
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |