Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Coolant Reservoir Replacement

Model: Volvo Xc90 MK 1 - Years 2002-2014
Part: Antifreeze coolant

Open the hood and ensure it is securely supported. Locate the coolant reservoir at the rear left (when facing the engine), detach it by pulling it upward, disconnect the hoses connected to it and the level sensor connector. Then, install the new reservoir by reconnecting the hoses and the connector, secure it to the vehicle's frame at the designated tabs, and restore the coolant level (you can also top off with distilled water if antifreeze is not available).

Updated on 4 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Windshield Washer Fluid Reservoir on a Volvo XC90
Replacing the Windshield Washer Fluid Reservoir on a Volvo XC90
Volvo Xc90 (2002-2014 / MK 1) Today, let's learn how to disassemble and replace the windshield washer fluid reservoir on a Volvo XC90. First, open the hood of the vehicle and star…
Guide to Replacing the Timing Belt on the Volvo XC90 2.4D
Guide to Replacing the Timing Belt on the Volvo XC90 2.4D
Volvo Xc90 (2002-2014 / MK 1) Today's information will show the steps for replacing the timing belt on the Volvo XC90 2.4D. First, open the hood and remove the upper plastic cover…
How to Replace the Cooling Radiator on a Volvo XC90 2.5L
How to Replace the Cooling Radiator on a Volvo XC90 2.5L
Volvo Xc90 (2002-2014 / MK 1) Today's main instructions will guide you through removing and replacing the cooling radiator on a Volvo XC90 2.5L. First, open the hood of the vehicl…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos