Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Rear Axle

Model: Volvo Xc90 MK 1 - Years 2002-2014
Part: Drivetrain

Lift the vehicle using a lift or appropriate jack stands. Remove the rear wheel corresponding to the axle you will be repairing; unscrew the bolt located at the center of the hub, which secures the axle to the hub itself; using a punch and hammer, tap the center of the axle to retract it a few inches. At this point, using the appropriate puller, remove the ball joint connected to the hub and complete the extraction of the axle from the hub; then remove the intermediate support of the axle near the boot on the transmission side and extract the axle from the transmission, ensuring that the end of the axle itself is intact.

Updated on 5 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing Front Fog Light
Replacing Front Fog Light
Volvo Xc90 (2002-2014 / MK 1) To facilitate disassembly, it is recommended to lift the vehicle on a hoist: the fog light bulb is accessed from inside the bumper. Disconnect the co…
Replacement of the timing belt of the Volvo XC90
Replacement of the timing belt of the Volvo XC90
Volvo Xc90 (2015-2026 / MK 2) Today's instructions will allow us to disassemble and replace the timing belt of the Volvo XC90. First, we open the hood of the vehicle and start by …
How and When to Replace the Timing Belt on the Volvo XC90
How and When to Replace the Timing Belt on the Volvo XC90
Volvo Xc90 (2002-2014 / MK 1) Today, let's go over the procedure and instructions on how and when to remove and replace the timing belt on the Volvo XC90. For the diesel engine, t…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos