Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Centre Console in a Volvo V70?

Model: Volvo V70 MK 2 - Years 2000-2007
Part: Center console tunnel

In this tutorial, see how to remove the centre console in a Volvo V70, a very simple and quick operation. First, position the gear lever in neutral, then unclip the small panel located under the climate control console and remove the screws accessible from the rear glove compartment. Remove the additional indicated screws, take off the left side panel, and unclip the gear lever gaiter from the base. At this point, remove the handbrake lever surround, disconnect the connector at the back, and separate the entire console from the floor.

Updated on 11 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How to disassemble the car stereo of the Volvo V70
How to disassemble the car stereo of the Volvo V70
Volvo V70 (2000-2007 / MK 2) Today's step-by-step instructions will guide us through the process of disassembling and replacing the factory radio of the Volvo V70. First, we get …
Replacement of the turn signal switch of the Volvo V70
Replacement of the turn signal switch of the Volvo V70
Volvo V70 (2000-2007 / MK 2) In this guide, we will see the main instructions that will allow us to disassemble and replace the turn signal switch of the Volvo V70. First, we ope…
Replace the Power Steering Fluid Reservoir on a Volvo V70
Replace the Power Steering Fluid Reservoir on a Volvo V70
Volvo V70 (2000-2007 / MK 2) This guide shows how to remove and replace the power steering fluid reservoir on a Volvo V70 in simple and quick steps. First, open the bonnet of you…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos