Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Alfa Romeo
    3. :
  3. 159
    4. : How to replace the headlight bulb on the Alfa Romeo 159?

Alfa Romeo 159 - Video tutorial

Model: Alfa Romeo 159 MK 1 - Years 2005-2011
Part: Light bulb
Operation: How to replace the headlight bulb on the Alfa Romeo 159?

The replacement of the Alfa Romeo 159 headlight bulb can be done by opening the hood to access the engine compartment and disconnect the connector located at the rear of the headlight. Once this has been removed, you can lower the two tabs that secure the bulb inside its housing and slide it out by removing it completely. The new bulb will then need to be connected to the connector and inserted into the housing. After the installation of the new part it will be possible to lower the hood and verify that the installed device works in the right way.


Posted on 8 June 2022 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • 159 2005-2011 - What type of lamps does the Alfa Romeo 159 have? Read Answer
    • 159 2005-2011 - Which bulbs do I need for the position lights of my Alfa Rome 159? Read Answer
    • 159 2005-2011 - Where is the Alfa Romeo 159 sidelight bulb located? Read Answer
    • 159 2005-2011 - What are the front position light bulbs of the Alfa Romeo 159? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos