Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to disassemble the third brake light in an Audi A4?

Model: Audi A4 B6 - Years 2000-2004
Part:

In this tutorial we can see how to remove the third brake light in the Audi A4, an extremely simple and quick operation. First of all, make sure that the key is not inserted, then open the trunk door and unhook the internal plastic cover. Next, locate the indicated hole, insert a screwdriver with a flat tip inside, and, using leverage, unlock the fastening clip. Close the trunk door at this point, remove the third brake light, and disconnect the power connector. To install the replacement, simply follow the reverse procedure.

Posted on 12 November 2024 by ScegliAuto

Video tutorial

Related tutorials

How to disassemble the third brake light of the Audi A4 B8
How to disassemble the third brake light of the Audi A4 B8
Audi A4 (2007-2016 / B8) In this article we will see how to disassemble the third brake light of the Audi A4 B8, this procedure is useful in case of malfunctions. To disassem…
How to disassemble the third brake light of the Audi A4
How to disassemble the third brake light of the Audi A4
Audi A4 (2014-2024 / B9) Today's instructions will allow us to disassemble and replace the tail light or third brake light of the Audi A4, in simple and quick steps. First, w…
Replace the stop on Audi A4
Replace the stop on Audi A4
Audi A4 (2000-2004 / B6) Replacing the rear stop on an Audi A4? Quite simple operation, let's see. We open the luggage compartment lid, unscrew the tightening screws on the s…

Installation of Upgraded Intercooler Radiator with Pipes

Lift the vehicle on suitable axle stands, remove the front wheels, and then the front bumper and grille. Proceed to remove the front headlights; drain the coolant, remove the intercooler radiator and the hoses connecting it to the intake system. Position the new intercooler radiator in the grille, temporarily securing it with cable ties, and mark with a marker the part of the metal that needs to be removed to allow the new hoses to pass through. Cut the marked portion of metal and apply a gasket to the edge. Remove the inner cover of the bumper and position it near the radiator to identify any interfering parts to eliminate: again, apply a gasket to the edge of the cut. Create brackets for securing the new radiator and proceed with the installation of the connecting pipes from the radiator to the intake, shaping and connecting them appropriately. Finally, reassemble the bumper, headlights, and grille.

Watch the video!


by ScegliAuto

More videos