Do it yourself
Frequently asked questions about cars and motorcycles

How to remove the lower rear light of the Audi Q3

Model: Audi Q3 F3 - Years 2018-2025
Part: Tail light

In this video, we will see how to remove the rear taillight, integrated into the bumper, of the Audi Q3: using a plastic spatula, we open the panel located on the rear bumper, in order to expose the screw inside; we remove it and then, always using the plastic spatula, we pry around the sides of the taillight, which is no longer screwed to the bumper. In fact, we can remove it by pulling it towards us, and then disconnecting the electrical connector: now, from the back of the optical group, we can change the bulbs according to our needs, turning the cap of each of them 1/4 turn counterclockwise: to put it back in place, we will act in the opposite direction. Reconnect the connector, put the headlight back in place and then screw the fixing screw back in. We can put the cap back on the bumper.

Posted on 22 May 2025 by ScegliAuto

Video tutorial

Related tutorials

Audi Q3 (2011-2018 / 8U) To replace the bulb of the rear bumper light on an Audi Q3, you need to remove the small plastic cover located on the bumper, directly under the ligh…
Audi Q3 (2011-2018 / 8U) Below we will see the instructions that will allow us to disassemble and replace the rear taillight of the Audi Q3, in simple steps. First, we open t…
Audi Q3 (2011-2018 / 8U) In this guide, we will see how to disassemble and replace the rear taillight of the Audi Q3. First, open the rear hatch of the trunk and start removi…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos