Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Audi
    3. :
  3. A4
    4. : How to bleed Audi A4 diesel pump

Audi A4 - Video tutorial

Model: Audi A4 B7 - Years 2004-2008
Part: Fuel pump
Operation: How to bleed Audi A4 diesel pump

If the high pressure pump is removed and reattached, for example to have it overhauled, it is absolutely essential that at the end of the installation, and before starting the engine, it is full of diesel and that all the air inside it has been evacuated, both to allow the engine to start and to ensure correct lubrication of the pump itself; then proceed by filling the pump with diesel oil with a syringe, injecting it both from the inlet and from the recovery side; at this point connect a vacuum pump to the recovery pipe of the diesel filter and pump until no more air bubbles can be seen in the circuit.


Posted on 6 September 2023 by ScegliAuto

    Frequently Asked Questions

    • A4 2007-2016 - Where is the fuel pump relay located in the Audi A4? Read Answer
    • A4 2007-2016 - Where is the tank float located in the Audi A4? Read Answer
    • A4 2004-2008 - Where is the fuel pump located in the Audi A4? Read Answer
    • A4 2007-2016 - Where is the high pressure fuel pump of the Audi A4 TFSI located? Read Answer
    • A4 2000-2004 - Where is the fuel pump of the 2002 Audi A4 located? Read Answer

How to reset the tire pressure warning light on Dacia Sandero?

Let's see below how it is possible to reset the low tire pressure signal on the car: first of all it is necessary to check the correct tire pressure by comparing it with the pressures reported in the use and maintenance manual. After that, turn on the ignition and locate the command on the right side of the steering wheel at the top that allows you to access the on-board computer menu, then select the car symbol, after which select the "up arrow" command up to that the indication "tire pressure" appears on the display. At that point, press the "Ok" control on the steering wheel and keep it pressed to reset the signal.

Watch the video!


by ScegliAuto

More videos