|
Do it yourself
| |||
| ||||
How to reset the service indicator on the BMW 530i
Model: BMW Serie 5
G30
- Years 2017-2024
In the following article, we will show you how to reset the service indicator light on the BMW 530i. No tools are needed for this procedure. To reset the oil indicator light, which in this car model is the service indicator light, you need to press the ignition button three times. Then, press the BC button located on the turn signal lever until a symbol appears on the left side of the dashboard. Hold the button until the service indicator light appears, then press it until you find the oil indicator light. Once you locate it, press and hold the button until the word "RESET" appears below the light. Release the button, then press it again and hold it to confirm the reset. Wait for the procedure to finish, then restart the instrument panel once the indicator light has been reset.
Posted on 24 August 2024 by ScegliAuto
Video tutorial
Related tutorials
BMW Serie 5
(2017-2024 /
G30)
This guide shows how to reset the warning for worn rear brake pads on the BMW 5 Series 530i G30. First, check the warning from the onboard computer: …
BMW Serie 5
(2017-2024 /
G30)
The Service indicator that is shown on the instrument panel of the BMW 5 Series can be reset by holding down the brake pedal and then pressing the ig…
BMW Serie 5
(1995-2003 /
E39)
The Service indicator that is shown on the instrument panel of the BMW 5 Series must be turned on by turning on the instrument panel, inserting the i…
Other guides you may be interested in
|
Where is the Fuel Filter Located in a Volvo XC60?
In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.472
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
