Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. X1
    4. : Cabin filter replacement on BMW X1

BMW X1 - Video tutorial

Model: BMW X1 E84 - Years 2009-2015
Part: Cabin air filter
Operation: Cabin filter replacement on BMW X1

To replace the cabin air filter, you must access from the outside of the cabin itself, so first lift the hood. Unscrew the six 8 mm (or 5/16 inch) bolts securing the pollen filter compartment cover located near the windshield. Remove the aforementioned cover e. VoilÃ! Here is the cabin filter! Open the clips that hold it in place and remove it. Similarly insert the new filter in the correct direction and close the clips. Reassemble and screw the lid back on and that's it. As you can see, this is an operation within everyone's reach.


Posted on 16 January 2024 by ScegliAuto



Replacement of the cabin air filter of the BMW X1
BMW X1 (2009-2015 / E84) Briefly, we will see the instructions that will allow us to disassemble and replace the air filter of the BMW X1 cabin, in simple and quick steps. Fi
Where is the cabin filter located in the BMW X1 and how do you replace it?
BMW X1 (2015-2022 / F48) In this video we can see where the cabin filter is located in the BMW X1 and how to replace it, which is a very simple and quick operation. As shown,
How to replace the cabin filter of the 2017 BMW X1
BMW X1 (2015-2022 / F48) Replacing the cabin air filter located inside your 2017 BMW X1 is a very simple operation, but at the same time it requires attention. Below we will

    Frequently Asked Questions

    • X1 2015-2022 - Where is the cabin filter on the BMW X1 located? Read Answer

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos