Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing Car Stereo for Repair

Model: BMW Serie 3 E91, E90, E92 - Years 2005-2013
Part: Car stereo

Remove the plastic trim, then unscrew the mounting screws of the stereo to allow for extraction. Disconnect the various connectors and remove the stereo. Remove the old additional wiring and install the wiring supplied with the new stereo, paying attention to the references. Connect the adapter to the antenna cable with the new connector. Reconnect the cables to the stereo by plugging in the respective connectors and insert the stereo into its slot, being careful not to pinch the wires until it is secured. Screw in the mounting screws. Turn on the stereo to check functionality.

Updated on 7 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Removing Car Radio for Repair
Removing Car Radio for Repair
BMW Serie 3 (1998-2006 / E46) Remove the plastic trim from the side moldings, then unscrew the retaining screws of the radio to allow for extraction. Disconnect the various connec…
How to dismantle the car radio of the BMW Series 3.
How to dismantle the car radio of the BMW Series 3.
BMW Serie 3 (2005-2013 / E91, E90, E92) The instructions provided in this guide will allow us to remove and replace the stock radio of the BMW 3 Series. First, we get inside the vehicle and…
Guide to Removing the Front Headlight
Guide to Removing the Front Headlight
BMW Serie 3 (1998-2006 / E46) The video guides you through the repair of the front optical assembly of your vehicle. First, remove the front turn signal as shown. Next, proceed to…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos