Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Remove the Fuel Tank on BMW 3 Series E30

Model: BMW Serie 3 E30 - Years: 1982, 1983, 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991, 1992

See other generations:
Video tutorial

In today's video, you will see how to remove the fuel tank from a first-generation BMW 3 Series E30. First, lift the vehicle, using jack stands if necessary, and drain the fuel from the tank by removing the vent cap. Next, unscrew the mounting bolts for the retaining brackets.

At this point, disconnect the various wiring harnesses and remove the fuel pump located under the rear seat, as shown in the video.

Finally, disconnect the tank hoses to extract it, following the video until the end!


Updated on 16 April 2026 by ScegliAuto


Related tutorials

How to Replace the Windshield Washer Reservoir on a BMW 3 Series E30
How to Replace the Windshield Washer Reservoir on a BMW 3 Series E30
BMW Serie 3 (1982-1992 / E30) Before you can start, open the hood of your BMW 3 Series E30. Begin by disconnecting the hoses and connectors attached to the windshield washer reser…
Instructions for Replacing the Floor Pan on BMW 3 Series E30
Instructions for Replacing the Floor Pan on BMW 3 Series E30
BMW Serie 3 (1982-1992 / E30) In this video, follow the main instructions to replace the floor pan of a BMW 3 Series E30 if it is in really poor condition. To remove the floor pan…
How to Replace the Right Fog Light Bulb on a BMW 3 Series E30
How to Replace the Right Fog Light Bulb on a BMW 3 Series E30
BMW Serie 3 (1982-1992 / E30) Using a medium flathead screwdriver, start by unscrewing and removing the two screws that secure the fog light to your BMW 3 Series E30. This will al…

Other guides you may be interested in

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos