Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removal and Installation of the Camshaft Position Sensor

Model: BMW Serie 5 E39 - Years: 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003
Part: Engine

See other generations:
Video tutorial

The necessary steps to perform the operation shown in the following guide consist of: 1) remove the battery cover of your car, 2) disconnect the negative battery cable, 3) remove the plug hole cover, 4) disconnect the sensor connector, 5) remove the installation bolt of the camshaft position sensor, 6) remove the sensor from the cylinder head cover.

To proceed with the installation, simply reverse the steps.

Ensure that the sensor you are installing is not contaminated with impurities that could lead to engine control deterioration.


Updated on 9 February 2026 by ScegliAuto


Related tutorials

Removal and Cleaning of the ICV Sensor
Removal and Cleaning of the ICV Sensor
BMW Serie 5 (1995-2003 / E39) The ICV (Idle Control Valve) is essentially a sensor that controls the throttle opening when there is low flow, typically below about 20% of the gas,…
Replacing the Crankshaft Position Sensor
Replacing the Crankshaft Position Sensor
BMW Serie 5 (1995-2003 / E39) Locate the position of the sensor on the engine block. The sensor is connected to the control unit via a cable that must be disconnected from the sen…
Replacing the ABS Speed Sensor
Replacing the ABS Speed Sensor
BMW Serie 5 (1995-2003 / E39) The ABS control unit speed sensor is located at the wheel, right behind the hub, and is secured with a 5 mm Allen bolt. To replace it, lift the vehic…

Other guides you may be interested in

How to Open the Fuel Filler Flap in the Hyundai i30?

In this tutorial, you will learn how to open the fuel filler flap in the Hyundai i30, a very simple operation that follows the typical procedure of most vehicles. First, unlock the locks using the designated button on the remote, then open the driver's door, locate the release lever on the left side of the seat, and operate it. Next, move to the fuel filler flap, open it completely, unscrew the cap, and refuel as needed. To close the flap, simply press it gently.

Watch the video!


by ScegliAuto

More videos