Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Where to Find and How to Remove the Cabin Air Fan of the BMW 5 Series F11

Model: BMW Serie 5 F11, F10 - Years: 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017
Part: Air conditioning

See other generations:
Video tutorial

This guide shows how to locate the cabin air fan of the BMW 5 Series F11. The cabin air fan is located inside the engine compartment, in the upper left corner, under the windshield. Access this component by removing the plastic cover using the two plastic clips.

Remove the Torx screws securing the battery connection box and move it aside. Remove the gas strut and the aluminum bar; remove the Torx screws securing the filter housing cover.

Disconnect the sensor connector and clean it. Check the condition of the front filter. Remove this assembly to reach the fan location.

Install a new unit or repair the old one and reassemble everything. Check the operation at maximum power for a few minutes.


Updated on 25 May 2026 by ScegliAuto


Related tutorials

Where is the cabin fan located in the BMW 5 Series?
Where is the cabin fan located in the BMW 5 Series?
BMW Serie 5 (2010-2017 / F11, F10) In this video we can see where the cabin fan is located in the BMW 5 Series and how to proceed in case we need to replace it. As shown, the fan in qu…
Removing the Fan Resistor on a BMW 5
Removing the Fan Resistor on a BMW 5
BMW Serie 5 (1995-2003 / E39) Is the air fan damaged? Let's see how to remove the fan resistor on a BMW 5. Use a pry tool to remove the plastic cover under the dashboard (on the c…
How do you disassemble the air fan in the BMW 5 Series E60?
How do you disassemble the air fan in the BMW 5 Series E60?
BMW Serie 5 (2003-2010 / E60, E61) The fan mentioned above can be disassembled both because it needs maintenance, for example by replacing the broken bearing, and because it is burnt a…

Other guides you may be interested in

How to Reset the Tyre Pressure Warning Light on the Jeep Renegade?

To reset the tyre pressure warning light on the Jeep Renegade, inflate the tyres until they reach the recommended pressure: this value is indicated on the sticker attached to the driver’s door pillar. Once the tyres are properly inflated, navigate through the menu that appears on the instrument cluster until you find the tyre pressure option. At this point, press and hold the OK button on the right side of the steering wheel to make the warning light disappear.

Watch the video!


by ScegliAuto

More videos