Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. Serie 5
    4. : How to replace the external rearview mirror of the BMW 5 Series E60.

BMW Serie 5 - Video tutorial

Model: BMW Serie 5 E61, E60 - Years 2003-2010
Part: Outside rearview mirror
Operation: How to replace the external rearview mirror of the BMW 5 Series E60.

If you want to replace the external rearview mirror of your BMW 5 Series E60 but don't know how to do it, don't worry because in the following mini guide you will find all the necessary instructions. Thanks to them, in fact, you will complete the entire maintenance operation in a few minutes and in total autonomy. First, open the door on the same side where the mirror to be replaced is located and remove the rubber protection located at the attachment of the mirror itself. Immediately after, disconnect the electrical connector and unscrew all the various screws present. Finally, remove the mirror and replace it with the new one.


Posted on 8 May 2023 by ScegliAuto



How to dismantle the external rearview mirror of the BMW 5 Series.
BMW Serie 5 (2003-2010 / E61, E60) Today in this guide, we will see the instructions that will allow us to disassemble and replace the external rearview mirror of the BMW 5 Series. Fir
How do you replace the external rearview mirror of the BMW 5 Series?
BMW Serie 5 (2010-2017 / F11, F10) In order to replace the external rearview mirror of the BMW 5 Series, you need to first remove the door panel: to do this, you will need to pry it wi
Remove the exterior mirror mirror on a BMW 5 Series
BMW Serie 5 (2003-2010 / E61, E60) How to remove the mirror from the outside mirror on a BMW 5 Series. With a spatula with plastic or rubber coating: let's pry between the perimeter of

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos