Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove Front Headlight on BMW 3 Series E90

Model: BMW Serie 3 E91, E90, E92 - Years 2005-2013
Part: Headlight

Removing the front headlight first requires removing the front bumper: start by removing the mounting pins along the lower edge, then remove the ones on the trim, and finally, remove the wheel well cover to access the pin that secures the bumper to the fender; pull the bumper forward and disconnect the fog light connectors; once the bumper is removed, access the wheel well to unscrew the first mounting pin of the headlight, two more pins are located next to the trim seat, and finally, the last two are on the cross member.

Updated on 19 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to remove the steering wheel of a BMW 3 Series E90?
How to remove the steering wheel of a BMW 3 Series E90?
BMW Serie 3 (2005-2013 / E91, E90, E92) The video shown here demonstrates how to remove the steering wheel of a BMW 3 Series E90, but the same procedure is also valid for other similar mode…
How to replace the headlight on the BMW 3 Series E90
How to replace the headlight on the BMW 3 Series E90
BMW Serie 3 (2005-2013 / E91, E90, E92) In this video tutorial we will see how to remove and replace the headlight on the BMW 3 Series E90-E91, following the instructions below. First we ar…
Guide to replacing the front headlight bulb of the BMW 3 Series.
Guide to replacing the front headlight bulb of the BMW 3 Series.
BMW Serie 3 (2005-2013 / E91, E90, E92) Below we will see step-by-step instructions on how to disassemble and replace the headlight bulb of the BMW 3 Series. To access the headlight bulb, i…

Other guides you may be interested in

How to Remove the Original Radio on a Honda CR-V

How do you remove the original radio on a Honda CR-V? First, use a plastic lever to remove the side cover of the radio (the air vents), then, with a screwdriver, unscrew the securing screws located on the sides (if present). After unscrewing the side screws (and disconnecting the clips) of the stereo, pull it out from its slot and remove it (disconnect the various power connectors at the back). To install the new stereo and the various removed parts, proceed in reverse order.

Watch the video!


by ScegliAuto

More videos