Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of Rear Bumper

Model: BMW Serie 3 E46 - Years 1998-2006
Part: Rear bumper

This guide explains the procedure for replacing the car's rear bumper. The procedure involves removing the retaining screws, replacing the part, and reattaching it. Perform the procedure on a flat surface using a jack. Once you remove the wheel, you will have direct access to the screw compartment. After removing the screws and bolts, being careful with the headlights, disconnect the parking sensors and any other wires, then attempt to remove the part. Once the old bumper is removed, simply replace it with the new one, starting by securing the first bolts above the bumper.

Updated on 20 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Rear Bumper on a BMW E91
How to Replace the Rear Bumper on a BMW E91
BMW Serie 3 (2005-2013 / E91, E90, E92) Replacing the rear bumper on a BMW 3 Series, model E91, is a straightforward task that you can do on your own with this tutorial. Start the replaceme…
Remove the Rear Bumper of a BMW 3 Series
Remove the Rear Bumper of a BMW 3 Series
BMW Serie 3 (2005-2013 / E91, E90, E92) Remove the rear bumper of a BMW 3 Series, here’s how to proceed: Unscrew the mounting screws (with a screwdriver or cordless drill) of the rear light…
Replacing the Rear Bumper on a BMW 3 Series
Replacing the Rear Bumper on a BMW 3 Series
BMW Serie 3 (1990-2001 / E36) Want to replace the rear bumper on your BMW 3 Series? Let's see how to remove it from the body. Remove the screws located at the bottom of the bumper…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos