Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removal and Replacement of the Transmission Cover

Model: BMW Serie 3 E46 - Years 1998-2006
Part: Transmission

First, shift the gear lever into neutral. In this position, press down on the lower front part of the knob and pull up to remove the lever from its housing. Now, use a plastic lever to unclip the cover from the sides to remove the clips. Disconnect the three electrical connectors attached to the cover. Pull the cover from its position. If desired, you can separate the cover from the leather trim. To do this, simply press the two clips holding the leather in place and separate it from the cover. The maintenance operation shown in the images is performed on a BMW 3 Series.

Updated on 21 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Removing the Center Console of Your Car
Removing the Center Console of Your Car
BMW Serie 3 (2005-2013 / E91, E90, E92) I will explain how to remove the center console of your car in simple steps, ideally with some experience. If your car has a manual transmission, put…
How to Remove the Automatic Transmission from the BMW 3 Series
How to Remove the Automatic Transmission from the BMW 3 Series
BMW Serie 3 (1998-2006 / E46) This guide shows how to remove the transmission case from the BMW 3 Series, following the instructions below. First, lift the vehicle and start unscr…
Removing the Starter Motor
Removing the Starter Motor
BMW Serie 3 (1998-2006 / E46) Before proceeding with the removal of the starter motor, it is recommended to disconnect the battery; the starter is mounted on the transmission case…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos